Description
Ridge pieces are used at the apex of the roof to join the two sides together and provide wall flashing trim. These galvanised steel flashing ridges are folded to a 130-degree internal angle and will flex 10 15 degrees either way, dependent on the angle of your roof. Secure them by stitching them, using ST22 stitching screws to the roofing sheet below.Allow an overlap of a minimum of 200mm when fitting roof barge boards end to end.
Please note: The 150 x 150 flashings give a coverage of 142 x 142 due to the 8mm welt. To produce high-quality, pre-coated sheeting, a system of multi-layered coatings are applied to a zinc coated, high-tensile steel strip and oven-cured to ensure optimum adhesion. This produces a roofing sheet with excellent corrosion resistance and climatic protection, together with abrasion resistance and high strength dripstop anti-condensation membrane is only available on box profile and corrugated profiles. Please contact us for further information: [email protected].
Reviews
There are no reviews yet.